damaged marble surface that requires multiple colors, blending is a great solution.
Things you will need:
Light Cure Acrylic™ Clear
Light Cure Acrylic™ Black
Step 1: Clean the area so that is free from any dust and dirt.
Step 2: Place the application tip on both syringes of the Clear and Black
Light Cure Acrylic™ material.
Step 3: Apply both colors to the surface and use the wooden applicator to mix
them together. Mix the colors in small amounts until it matches the color of your surface.
Step 4: Use the cloth and remove any excess material from the surrounding areas. Leave the LCA material only in the defected area. Using the wooden applicator, gently touch the top of the curing strip to help push the repair material into the damage. If your damage is larger than a curing strip, you can use clear packing tape, folded sticky side to sticky side.
Step 6. Activate the LED light just above the curing strip and make sure you focus in different sections of the damage. Time will vary depending on the size of the defect.
Step 7: Remove the curing strip and verify for a complete cure. If the repair remains tacky after additional LED exposure, you may use rubbing alcohol to gently wipe it off.
Always be extremely careful when sanding surfaces like cultured marble or acrylics. Hazing or scratching may occur if you are too aggressive.
Step 8: Use the yellow 220 grit sandpaper to remove any over filled material.
Rub in gentle circles. Then for increased shine, use the included grey 2000 grit wet sanding paper with a dab of water.
* all components and detailed step by step instructions are included in the DIY Kit.
